Corefix AIR Heavy Duty Dot & Dab Wall Fixing for Flat Screen TVs, Radiators, Boilers, Wall Cabinets & Shelving | 4 Pack

Product Information

This is the nill strength bit (plaster board and plaster dab or air gap) Add this length to your normal size screw and buy them... the longer ones! Once a boiler is on the wall I always test my fixings by giving a little pull to ensure it has held solidly. With Corefix I had no fears. I’d 100% recommend all installers carry these fixings, they make life so much easier.”

I used the Corefix fittings while mounting a uni-strut to support a low loss header and I was impressed. It’s the best fixing of its kind that I’ve used. They are very strong and didn’t distort the plasterboard on the surface at all. I only used them on medium weight items, not on rads/boilers yet, but I’m sure they’ll be up to the job.This clearly depends on the size of the television but with all the major brands such as Sony, Samsung & Panasonic all making flat screen TVs up to a staggering 100 inches and above in some cases, it really is important to know the weight of your TV and know your hollow wall plasterboard fixing will support the load. Below are some approx. weights for standard size wall mounted flat screen TVs* Remove any dust or debris from the hole before gently tapping the Corefix plug into place until the flange sits against the plasterboard. gently screw a screw just onto the end of your wall plug (not so far as to open the wall plug to much) tap the screw and wall plug through the plaster board into I saw Corefix at Installer2018, and was very impressed with the design and thought it was reasonably priced. It is very effective and gives fantastic support, bridging the gap on a dot and dab wall and saving time because you don’t need extra support. I was particularly impressed by how solid the fixings held considering they were supporting a boiler, which was 35mm away from the surface it was fixing onto.

Corefix can be installed in less than one minute, without the need for specialist tools – all you need is a 10mm masonry drill, hammer, and a screwdriver: I used them to hang a 42kg vertical radiator on a drylined wall and the fittings were very good, with nice simple instructions. I was most impressed with the simplicity of the fittings, they’re very effective and strong, I dropped the rad on and they didn’t move at all. There are some additional workarounds possible though - adding something to transfer the clamping force required to the masonry behind so that the screw doesn't deflect downwards under the load of the mounted item and the board doesn't deflect towards the wall due to the clamping force. I've used appropriate lengths of 15mm copper pipe or, for heavier loads such as large radiators, slices of a broom handle (with a hole drilled through the centre) to do this and it works perfectly fine.

Corefix is a unique heavy duty fixing system for dot and dab wall construction, a method used almost exclusively in the UK’s new build homes.